Jump to content
Medved Trader Forums
rocarr

MT not running after update

Recommended Posts

A box popped up saying I would have to manually install the new version of MT. I downloaded the update and it would pause several times when installing. After about 20 minutes it finally finished but nothing happens when I try to start it. I am running the latest version of Windows 10 and don't have problems with any other software I am using. I can't send a log file since I can't get into the program. I tried installing the program in safe mode with the same results.

Share this post


Link to post
Share on other sites

1) reboot Windows

2) run the install

you said that it pauses several times while installing - is it doing that after reboot? If so, it is most likely your security software. Which software are you using?

Share this post


Link to post
Share on other sites

Well I did a system restore back about a month and now MT will start but I am getting this error:

 Medved Trader encountered a critical error and will need to shut down

Could not load file or assembly 'TeeChart.Client, Version=4.1.2012.1311, Culture=neutral, PublicKeyToken=5852dc2e94c7ab4b' or one of its dependencies. The module was expected to contain an assembly manifest.

Please contact Medved Trader technical support and provide the error details

AppVer: 1.1.8210.2 Err.Flags: Log, ShowIndicator, ShowToUser, ShowSync
System.BadImageFormatException:
   at MT.App.CloseWindowsNotInLayout(List`1 layout)
   at MT.App.ApplyLayout(MTConfigList`1 newLayout) in C:\MedvedTrader\MT\App.cs:line 2502
   at MT.App.Application_Startup() in C:\MedvedTrader\MT\App.cs:line 5794

Share this post


Link to post
Share on other sites

I sent you email w/ a similar problem

red stop circle for data streaming greeted me this AM

I restarted MT and still no data stream. Red circle still there

I saw an update wh/ I installed and MT started fine, but still no streaming data, still red circle

what to do?

what to do?

Share this post


Link to post
Share on other sites

 

Setup on PC

Setting up 8.8.8.8 takes two minutes and requires no technical skill or special software. Even if you’re a computer novice, pick your device below for an easy-to-follow setup guide.Click on the Start menu, then click on Control Panel.

  1. Click on Network and Internet.
  2. Click on Change Adapter Settings.
  3. Right click on the Wi-Fi network you are connected to, then click Properties.
  4. Select Internet Protocol Version 4 (or Version 6 if desired).
  5. Click Properties.
  6. Write down any existing DNS server entries for future reference.
  7. Click Use The Following DNS Server Addresses.
  8. Replace those addresses with the 8.8.8.8 DNS addresses:
    • For IPv4: 8.8.8.8 and 8.8.4.4
  9. Click OK, then Close.
  10. Restart MT.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...