kui Posted April 16, 2014 Report Share Posted April 16, 2014 once setting custom fib levels, how do we get them to take effect and overide the parameters that are standard. did I also see a past post where you were going to include settings in both directions from zero? Quote Link to comment Share on other sites More sharing options...
Jerry Medved Posted April 16, 2014 Report Share Posted April 16, 2014 both directions from zero - you can enter negative values now. That was done a while ago. Custom values do not override standard ones. Once you define custom values, when you go to parameters for a Fib Retracement, those custom values will be available along with the standard ones. Quote Link to comment Share on other sites More sharing options...
kui Posted April 16, 2014 Author Report Share Posted April 16, 2014 done. what is happing when I begin the fib at point 'A' (thinking this is zero) and draw - then point 'B' at the end of the draw becomes zero and my point 'A' value is 100 Quote Link to comment Share on other sites More sharing options...
Jerry Medved Posted April 16, 2014 Report Share Posted April 16, 2014 the starting point of the drawing is not what determines the 100 or 0 %. 100% is always on the left point, which is the same as it was in QT. Quote Link to comment Share on other sites More sharing options...
kui Posted April 16, 2014 Author Report Share Posted April 16, 2014 it works just fine after I stretched my charts out and made the levels more visable. the right side stretch and moving of chart is so much more easier than QT - Well Done! thx JM Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.